![]() Unified Access Gateway appliances are preferred over Horizon Security Servers for the following reasons: Unified Access Gateway (formerly known as Access Point).There are two VMware-provided remote access solutions for Horizon View: UAG appliances vs Horizon Security Servers But the CLI commands for Security Server load balancing are preserved at the bottom of this post. Horizon Security Servers – Detailed configuration for Horizon Security Servers have been removed from this version of the post.If you enabled the Secure Gateways (PCoIP, Blast) on the Connection Servers, then load balance the Connection Servers using the same procedure as load balancing UAGs.See the CLI commands for a sample configuration. Internal Horizon Connection Servers – This is standard load balancing on SSL_BRIDGE protocol, port 443, and Source IP persistence.To simplify this post, this post is focused on Unified Access Gateway, which is the replacement for Horizon Security Servers.įor load balancing of other Horizon components: 2018 Jan 27 – in the Load Balancing Monitors section, added UAG DDoS changes from UAG breaks after a few days.2018 Jan 28 – in the Overview > Protocols/Ports section, added link to Aresh Sarkari Persistence Profile – F5 LTM Load Balancing for VMware Unified Access Gateway Appliance.Updated Monitor instructions for NetScaler 12.0 build 56 and newer.2018 Dec 21 – Updated screenshots for ADC 12.1.2020 July 29 – removed /broker/xml monitoring (source = VMware 56636).2021 June 16 – fixed quiesce mode by configuring TROFS (transition out of service) in the monitor (h/t Henry Heres).Use this procedure to load balance VMware Unified Access Gateway (formerly known as Access Point).Ĭitrix ADC is the new name for NetScaler.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |